Remotec Z-URC550 V1 Manual de usuario descargar pdf (Pagina 14)

scene successfully

Note1: This process will only remove the target device/EP from its

assigned scene but will not exclude it from the network.

Deleting a Scene

Step Setup Key LED Indication Status

Press in Advance

Setup

• The “OK＂ light turns

Press

• “OK＂ LED flashes

once and stays on

• “LED_A＂ flashes

slowly

Select a scene number

from 1 to 16 (1-8 or

1-8)

• “OK＂ LED flashes

once then turns off

• “LED_A＂ off

• Scene deleted from the

scene successfully

Note1: This process will only remove the scene devices/EPs from its

assigned scene but will not exclude it from the network.

Note 2: The above steps are needed if Z-URC

550EU to be a

secondary remote controller and the Scene information mapping from

gateway / primary controller is unsuccessful.

Scene Operation

After the scene setup is done, you can trigger the desired scene via

scene control keys in front panel of the Z-URC

550EU. (Figure 4)

The green “OK＂ LED flashes when the operation is successful, and

the red ERROR LED flashes when it’s failed.

Figure 4 Scene Control Keys of the Z-URC

550EU

Scene

Control Ke

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Sin comentarios

Remotec Z-URC550 V1 Manual de usuario Pagina 14