Remotec Z-URC550 V1 Manual de usuario descargar pdf (Pagina 17)

Deleting a group

Step Setup Key LED Indication Status

Press in Advance

Setup

• The “OK＂ light turns

Select a group number

from 1 to 16 (1-8 or

1-8)

• “OK＂ LED flashes

once and stays on

• “LED_A＂ off

• “LED_B＂ flashes

slowly

• Delete a group

completed

Note1: This process will only remove the group devices/EPs from its

assigned group but will not exclude it from the network.

Note 2: The above steps are needed if Z-URC

550EU to be a

secondary remote controller and the Group information mapping from

gateway / primary controller is unsuccessful.

Assign Association for Two Devices

The Z-URC

550EU can be used to assign one device to

automatically interact directly with another device.

For example you can assign a door sensor (primary node) to turn on the

light switch (secondary node) when the door is opened.

Adding Device/End-point to an Association Group

Step Setup Key LED Indication Status

Press in Advance

Setup

• The “OK＂ light turns

Press

• “OK＂ LED flashes

once and stays on

• “LED_A＂ flashes

slowly

Select a group number

from 1 to 16 (1-8 or

1-8)

• “OK＂ LED flashes

once and stays on

• “LED_A＂ off

• “LED_B＂ flashes

slowly

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Comentarios a estos manuales

Sin comentarios

Remotec Z-URC550 V1 Manual de usuario Pagina 17

Comentarios a estos manuales