Remotec ZRC-100 V1.53 Manual de usuario descargar pdf (Pagina 45)

4

Placethetwocontrollers

closetoeachother.



(LCDdisplayOK

ifthe

learningmodeis

successful.

LCDdisplayERROR

ifthe

learningmodeis

unsuccessful.)



⇓



LCAUTION

SceneControllerConfigurationCommandandAssociationCommand



Ifscenesarecopiedtoasecondarycontrollerusingthereplication

function,thosescenescannotbemodifiedusingtheSceneController

ConfigurationandAssociationCommands.Ifmodificationsaredesired,it

isrecommendedtodeleteallthesescenesfromthecontrollerpriorto

usingthetwoaforementionedcommands.



ScanDevicesfromnetwork



In most cases, Z-Wave gateway is the primary controller (control

center), all Z-Wave devices will be added / (inclusion) by the Z-Wave

gateway. Normally, it is need to click the PROG button of the Z-Wave

device to add into the network and one by one. The gateway will create

a control page / section to Z-Wave devices. User can control / monitor

Z-Wave devices under the control page.

ZRC-100 can discover all existing Z-Wave devices from the network

and no need to click the PROG button one by one

, discovered devices

will be re-assigned to their default categories (Devices, Comforts and

Sensors), and names will be re-assigned with default naming in

ascending order which is implemented by the function of “Scan

Devices”.

Learning Mode

Learnin

…

>>>>

Learning Mode

Learnin

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 60 61

Comentarios a estos manuales

Sin comentarios

Remotec ZRC-100 V1.53 Manual de usuario Pagina 45

Comentarios a estos manuales

Relacionado con productos y manuales para Control remoto Remotec ZRC-100 V1.53