Remotec ZRC-100 V1.53 Manual de usuario descargar pdf (Pagina 46)

To implement this function, your ZRC-100 is needed to follow below

steps:

1) Assume all Z-Wave devices have been added by gateway.

2) ZRC-100 should act as a secondary controller (receive all

network and device information from a primary controller),

please refer to “Learning Mode” section in this manual.

3) Execute the “Scan Devices” function with below steps.

Step SetupKey LCDIndication

1

Pressandholdcbkeys

simultaneouslyfor3

secondsunderthe

Homepage.



⇓



2

Select“ScanDevices”

andpress

key.



3

Pressfkeytoconfirm

scandevicesorpresse

keytocancelitandgo

backtopreviouspage.



The remote will scan all

devices from network,

discovered devices will

be re-assigned to their

default categories

(Devices, Comforts and

Sensors) names will be

re-assigned in ascending

order. The LCD will

display OK and go back

to previous page when it



⇓



Home

Device >

Scene >

Comfor

OK to Enter

O Confirm? YES f

Scan Devices

will erase all existing

device names

Caution! This action

Scan Devices

This will take

Waitin

from several min

to one hr! 1/5

Network Setup

Learnin

Mode >

Create Pri. >

OK to Enter

Scan Devices >

Network Setup

Learnin

Mode >

Create Pri. >

OK to Enter

Scan Devices >

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 60 61

Comentarios a estos manuales

Sin comentarios

Remotec ZRC-100 V1.53 Manual de usuario Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para Control remoto Remotec ZRC-100 V1.53